spoolend_new 【疑难问题解决记录】串口回显直接在read后调用，处理按帧的数据时才需要在回调中处理

project/Spoolend/Spoolend.c

@@ -104,12 +104,12 @@ static int check_Spoolend(char *_pBuffer, uint32_t _iSize)
 
 static void decode_RS485_1(const char *_pBuffer, uint32_t _iSize)
 {
-	rd_ComWrite(g_ptRS485_1, (char *)_pBuffer, _iSize);
+	//rd_ComWrite(g_ptRS485_1, (char *)_pBuffer, _iSize);
 }
 
 static void decode_RS485_2(const char *_pBuffer, uint32_t _iSize)
 {
-    rd_ComWrite(g_ptRS485_2, (char *)_pBuffer, _iSize);
+    //rd_ComWrite(g_ptRS485_2, (char *)_pBuffer, _iSize);
 }
 
 static void decode_Spoolend(const char *_pBuffer, uint32_t _iSize)
@@ -187,13 +187,13 @@ void SpoolendTask(void)
 	char pcBuffer2[52] = {0};
 	char pcBuffer3[52] = {0};
 	__disable_irq();
-	rd_ComRead(g_ptRS485_1, pcBuffer1, sizeof(pcBuffer1));
-	rd_ComRead(g_ptRS485_2, pcBuffer2, sizeof(pcBuffer2));
+	int i485_1 = rd_ComRead(g_ptRS485_1, pcBuffer1, sizeof(pcBuffer1));
+	int i485_2 = rd_ComRead(g_ptRS485_2, pcBuffer2, sizeof(pcBuffer2));
 	rd_ComRead(g_ptFDCAN1, pcBuffer3, sizeof(pcBuffer3));
 	__enable_irq();
 
-//	rd_ComWrite(g_ptRS485_1, "Hello\n", 6);
-//	rd_ComWrite(g_ptRS485_2, "Hello\n", 6);
+	if (i485_1 > 0) rd_ComWrite(g_ptRS485_1, pcBuffer1, i485_1);
+	if (i485_2 > 0) rd_ComWrite(g_ptRS485_2, pcBuffer2, i485_2);
 //	rd_ComIDWrite(g_ptFDCAN1, 1, "Hello\n", 6);
 
 	HAL_GPIO_TogglePin(LED1_GPIO_Port, LED1_Pin);
@@ -208,6 +208,5 @@ void SpoolendTask(void)
     rd_ComSendProc(g_ptRS485_1);
     rd_ComSendProc(g_ptRS485_2);
     rd_ComSendProc(g_ptFDCAN1);
-    HAL_Delay(10);
 }